We recommend that all central air conditioner
repairs must be handled by an EASY AC Repair Specialist. Following, you'll find
guidance to diagnose the problem based on symptoms.
Ac Not Cooling Palm City fl - Air
conditioner is not cooling-
Typically, when an air conditioner runs and
doesn't push cold air may just need to be cleaned. This diagnosis is best
performed on a warm to hot day. Make sure to read your owner's manual before
performing steps below.
1) Make sure power is off to the unit. If not,
locate the shut off panel which is normally near the house wall next to the
outdoor unit. If the shut off panel is not located there, shut off the air
conditioner's switch at the main electrical panel.
2) Find the outdoor condenser and clean all dirt, leaves and debris away.
3) Locate the protective grille or cover and remove from the air conditioner condenser's fins.
4) With a soft brush, clean dirt and debris from the fins. Very carefully, vacuum the fins with a soft vacuum brush attachment. Be careful, and do not damage the fins.
2) Find the outdoor condenser and clean all dirt, leaves and debris away.
3) Locate the protective grille or cover and remove from the air conditioner condenser's fins.
4) With a soft brush, clean dirt and debris from the fins. Very carefully, vacuum the fins with a soft vacuum brush attachment. Be careful, and do not damage the fins.
Ac Not Cooling Palm City fl - 5)
Now for the top grille- Locate the screws, unscrew and remove from the unit.
The fan may be attached to the grill. If so, take careful steps not to
disconnect wires.
6) Once inside, begin hosing down the fins lightly. To much water pressure can damage the fins.
7) Assemble the unit as you found it. 8) Now time to test. Reset the power and set the thermostat to a cool temperature, around 72 degrees should work. Let the air conditioner run for 5 minutes. Now, feel the two pipes that connect to the condenser unit. One of the pipes should be cold, and the other should feel warm.
6) Once inside, begin hosing down the fins lightly. To much water pressure can damage the fins.
7) Assemble the unit as you found it. 8) Now time to test. Reset the power and set the thermostat to a cool temperature, around 72 degrees should work. Let the air conditioner run for 5 minutes. Now, feel the two pipes that connect to the condenser unit. One of the pipes should be cold, and the other should feel warm.
About The Author :-
Ac Not Cooling Palm City fl - Adam’s
Air Conditioning Inc, Serving Palm Beach County, Martin County, St. Lucie
County & Indian River County Since 1997. Factory Authorized Service of All
Major Brands. At Adam’s Air Conditioning we take pride in having only highly
trained staff that can attend to all your air-conditioning needs. All of our
technicians and mechanics are EPA
certified and R410 certified.
Contact Details :-
Adam’s Air Conditioning
Inc,
582 NW
Merchantile Place
Port Saint Lucie, Florida 34986
Always open
Phone 772-337-6559 or 561-252-6330
Email info@adamsairconditioning.net
Website http://www.adamsairconditioning.net
Port Saint Lucie, Florida 34986
Always open
Phone 772-337-6559 or 561-252-6330
Email info@adamsairconditioning.net
Website http://www.adamsairconditioning.net
No comments:
Post a Comment